Club Car Precedent 2004, Техническое обслуживание и сервис

Страница: 24 / 212

BODY AND TRIM Floor Mat and Retainers
Page 4-6 2004 Precedent IQ System Golf Car Maintenance and Service Manual
4
FLOOR MAT AND RETAINERS
See General Warnings, Section 1, Page 1-1.
The floor mat retainers secure the floor mat to the vehicle and also provide a clean appearance to the side of
the vehicle. Normally, if only the floor mat (3) needs to be removed, the screws (2) can be loosened slightly to
allow the floor mat to be slid from beneath the retainers (1)
(Figure 4-3, Page 4-6) .
FLOOR MAT RETAINER REMOVAL
1. Remove screws (2) from top of retainer (1) (Figure 4-3, Page 4-6) .
2. Remove screw (4) from lower rear corner of retainer. This screw threads into a J-clip (5) that is attached
to the rear underbody.
3. Carefully pull on retainer to separate the trim clips from their respective slots. Trim clips do not normally
need to be removed from the retainer.
FLOOR MAT RETAINER INSTALLATION
1. Position the retainer on the vehicle and press firmly to engage the trim clips to the vehicle (Figure 4-3,
Page 4-6) .
2. Install one screw (4) at the lower rear of the retainer. Tighten screw to 1.8 ft-lb (2.5 N·m).
3. Ensure the floor mat is properly positioned beneath the top flange of the retainer and install two screws
(2). Tighten screws to 4.4 ft-lb (6.0 N·m).
Figure 4-3 Floor Mat Retainer
TO BODY
TRIM CLIPS 4 PLACES
3
2
1
4
5