Club Car Carryall 1, Дополнение к руководству по обслуживанию и ремонту, Страница: 87 / 176

ELECTRICAL COMPONENTS Solenoid
2008-2011 IQ System Electric Vehicle Maintenance and Service Supplement Page 13-9
13
ONBOARD COMPUTER (OBC)
See General Warning, Section 10, Page 10-1.
Testing the Onboard Computer
See Section 11, Test Procedure 2, Page 11-18, Test Procedure 10, Page 11-35, and Test Procedure 11,
Page 11-35.
Onboard Computer Removal
1. Disconnect the batteries and discharge the controller. See Disconnecting The Batteries on page 10-3.
2. Remove rear body access panel and unplug the six-pin connector (16) at the OBC (Figure 13-9,
Page 13-9) .
3. Remove the two screws (5) from the speed controller cover (1) and remove the cover (Figure 13-10,
Page 13-11) .
4. Remove the wire tie (3) securing the speed controller wires to the mounting plate.
5. Remove black 6-gauge wire (14) from the speed controller B– terminal (Figure 13-9, Page 13-9) .
6. Disconnect the gray wire fuse holder at the charger receptacle.
7. Disconnect the black 10-gauge wire (8) at the charger receptacle.
8. Cut the wire tie that secures the OBC wire harness to the I-beam.
9. Loosen, but do not remove, the two self-tapping screws (17) holding OBC to component mounting plate.
10. Slide OBC towards outside of vehicle and align heads of self-tapping screws (17) with the two holes in
the OBC face plate. Pull OBC towards rear of vehicle and remove from component mounting plate.
Figure 13-9 Onboard Computer
16
14
2
1
13
17
8
14
9
6
8
7
10