Club Car Carryall 1, Дополнение к руководству по обслуживанию и ремонту, Страница: 80 / 176

ELECTRICAL COMPONENTS Key Switch
Page 13-2 2008-2011 IQ System Electric Vehicle Maintenance and Service Supplement
13
Key Switch Removal, Continued:
2.4. DS Villager 4 Vehicles: Pull center dash out approximately 1 inch (2.5 cm) from the frame and then
bend the top right corner of the center dash inward while pulling the top of the panel out and down.
See following NOTE.
NOTE: Bending the top right corner of the center dash inward during removal will prevent the terminals (7)
on the back of the key switch from touching the metal frame around the dash.
(Figure 13-1,
Page 13-1)
2.5. Turf 1 and Carryall 1 Vehicles: Pull center dash out from the frame and disconnect the wires from
the electrical components mounted on the dash panel. Do not allow wires to touch. See following
NOTE.
NOTE: Take care to prevent key switch terminals and wires from touching the metal frame around the
dash.
(Figure 13-1, Page 13-1) .
3. Slide center dash panel up steering column by snapping top out and then rotating the panel out and up.
4. Disconnect the wires from the key switch. Do not allow wires to touch.
5. From the back of the dash panel, push down on the retaining tabs surrounding the key switch (4) and
remove the key switch cap (8). Hold the key switch and remove the switch retaining nut (6) from the out-
side of the dash panel
(Figure 13-2, Page 13-2) .
Key Switch Installation
1. Position the key switch and flat washer (9) in the center dash, then install and tighten the switch retaining
nut (6) to 40 in-lb (4.5 N·m). Install key switch cap (8) in center dash (Figure 13-2, Page 13-2) .
Figure 13-2 Key Switch
4
6
8
9
7