Club Car Carryall 1, Дополнение к руководству по обслуживанию и ремонту, Страница: 84 / 176

ELECTRICAL COMPONENTS Motor Controller Output Regulator (MCOR)
Page 13-6 2008-2011 IQ System Electric Vehicle Maintenance and Service Supplement
13
MCOR Removal
1. Disconnect the batteries and discharge the controller. See Disconnecting The Batteries on page 10-3.
2. Place chocks at rear wheels and lift the front of the vehicle with a chain hoist or floor jack. Place jack
stands under the round tube crossmember of the frame to support vehicle. See WARNING “Lift only
one end...” in General Warning, Section 10, Page 10-2.
3. Disconnect the two-pin and three-pin connectors (1) from the MCOR (2) (Figure 13-6, Page 13-6) .
4. Remove the hex-head screws (3) connecting the MCOR to the frame I-beam.
5. Remove the MCOR from vehicle.
6. Push the drive bar (4) into the hole in the I-beam to disengage it from the accelerator pivot rod (5).
MCOR Installation
1. Insert the splined end of the drive bar (4) through the hole in the passenger-side frame I-beam as shown
(Figure 13-6, Page 13-6) .
2. Position the opposite end of the drive bar so that the accelerator pedal sits between the two pins.
3. Place the MCOR (2) onto the splined end of the drive bar (Figure 13-6, Page 13-6) . See following
NOTE.
Figure 13-6 Motor Controller Output Regulator (MCOR) Mounting
3
4
5
1
2