CLS Manuals
CLS Atmosphere LED-panel
www.cls-led.com
- 3 -
- 4 -
CLS CAS 6 Luxeon K2-TFFC
INSTALLATION
This section shows how to install the CLS CAS 6.
ATTENTION!
TO prEvENT dAmAgE TO ThE CLS CAS 6, uSE ThE INCLudEd
CLS CAS 6 SLEEvE. mAkE SurE drAINAgE CONdITIONS ArE
AdEquATE. ThESE prECAuTIONS muST bE fOLLOwEd,
OThErwISE ThE wArrANTy wILL bECOmE INvALId!
W
ARNING
Drainage
To minimize the risk of flooding or water logging, install the fixture in a location which is above the level of
the surrounding area, and make sure drainage conditions are adequate. CLS recommends to use gravel for
the best drainage conditions. The unit is not designed to withstand high pressure water jets.
Protection from burns and fire
• Do not install the CLS CAS 6 near a heat source.
• Do not install the CLS CAS 6 in a corrosive, flammable or explosive area.
• Do not modify the CLS CAS 6, or install other than genuine parts.
• Do not operate the CLS CAS 6 if the ambient temperature exceeds 40 ºC.
• Do not stare into the LED, this can cause damage to the eyes.
Protection from injury due to falls
• Verify that all covers and mounting hardware are securely fastened.
• Block the access below the work area whenever installing or removing the unit.
CAbLE INSTALLATION
Cable slack
Allow at least 300 mm of free cable in the installation, so that the CLS CAS 6 is clear for service without
disconnecting cables.
NOTE!
For protection from potentially lethal electric shock:
• The CLS CAS 6 must be grounded.
• The AC-power supply must be fitted with a fuse or circuit breaker, ground-fault protection, and a means
to isolate the CLS CAS 6 from power during service or when not in use.
• Cables and fixtures must be isolated from power, and steps taken to prevent reconnection, before carrying
out any work on them.
• Do not connect the CLS CAS 6 to an electrical dimmer system: doing so can damage the electronics.
Connecting to AC-power
Connect the power cable only on the right positions! See diagram for the colours of all electric cables:
Wire (EU)
Function
Marking
Brown
Live
L
Blue
Neutral
N
Yellow/green
Earth
Obstruction by roots
The further the CLS CAS 6 is located from vegetation such as trees, hedges or bushes, the less chance there
is that the roots will obstruct the CLS CAS 6 or even cause damage to its cables. If the CLS CAS 6 is located
close to vegetation, consult a landscape architect about the solutions for the root obstruction.
