CLS Manuals
CLS Atmosphere LED-panel
www.cls-led.com
- 5 -
- 6 -
CLS CAS 6 Luxeon K2-TFFC
The CLS CAS 6 with Flood lenses.
Disassemble the stainless steel
ring by loosening the 5 screws.
Semi-tighten the screws by order
(crosswise) as shown in picture 6
on the stainless steel ring. To keep
the CAS 6 IP65 (waterproof).
Repeat the previous steps to
tighten the screws and the CLS
CAS 6 is ready to be used with
the spot lenses.
Carefully lift the lens plate out of
the CAS 6 unit.
Now carefully place the Spot Lens
plate in the CAS 6. Make sure the
lenses are placed on the LEDs.
LENS PLATE INSTRUCTION
Install example
Disassemble the stainless steel ring from
the CLS CAS 6 by loosening the 5 screws.
Assemble the stainless steel ring back on
the CAS 6 unit. The CAS 6 is ready to be
installed.
To install the CAS 6 into the sleeve, tread
the wire trough one of the holes on the
side. Slide the CAS 6 unit inside and
secure it in the screw holes.
Install the CAS 6 into the ground. Finish
the surface around the CLS CAS 6 with
gravel. Ensure that the foundation will
withstand pressure on the CLS CAS 6.
