USER MANUAL :
DOCUMENT NAME
To switch between the Diagnostic Mode and Command Mode, simply press
from the Diagnostic Mode to Command Mo
executing. Command Mode is shown with the [COMMAND MODE] text in the communications block.
responses will be displayed in the 'Communications' block. This information ca
selecting the 'Clear Screen' option.
The logger must be in 'Command Mode' before any of the settings changes or other instructions are accepted
command in Diagnostic Mode will cause the
The information on this screen is ordered in various groups. The 'General Details' box holds information that is not alterabl
and is general information about the logger. This information consi
Information
Device Code
Firmware Version
Serial Number
Signal Strength
The Device Code assigned to this particular
addressing this code. This code is unique to all
manufacture.
Firmware version of the software loaded on the
Serial number of this
Signal strength of the last GSM communications, expressed as a percentage.
MANUAL : CDS546 NIMBUS LOOP LOGGER
NAME
CLASSIFICATION
DATE
PAGE
To switch between the Diagnostic Mode and Command Mode, simply press the 'Command/Connect' button. Switching
from the Diagnostic Mode to Command Mode can take several seconds depending on what the
executing. Command Mode is shown with the [COMMAND MODE] text in the communications block.
responses will be displayed in the 'Communications' block. This information can be cleared by right clicking in this box and
before any of the settings changes or other instructions are accepted
command in Diagnostic Mode will cause the logger to switch to Command Mode but that last instruction will
The information on this screen is ordered in various groups. The 'General Details' box holds information that is not alterabl
. This information consists of the following data:
Notes
The Device Code assigned to this particular logger. All communications are initiated by
addressing this code. This code is unique to all loggers and is assigned at the time of
Firmware version of the software loaded on the logger
Serial number of this logger - assigned in the factory.
Signal strength of the last GSM communications, expressed as a percentage.
PAGE
'Command/Connect' button. Switching
de can take several seconds depending on what the logger is currently
executing. Command Mode is shown with the [COMMAND MODE] text in the communications block. All commands and
n be cleared by right clicking in this box and
before any of the settings changes or other instructions are accepted
. Sending a
itch to Command Mode but that last instruction will fail.
The information on this screen is ordered in various groups. The 'General Details' box holds information that is not alterable
. All communications are initiated by
s and is assigned at the time of
Signal strength of the last GSM communications, expressed as a percentage.
