ClipperCreek ProMountDuo PMD-10T, Руководство по установке

Страница: 34 / 40

Page 34
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
ClipperCreek
, Inc.
Figure 41
5. CONNECT THE WIRING
a. The ground conductor and ground lug
connections inside the Pedestal Post must be
completed at this time. The ground lugs have
a 3/16” Hex screw (Allen screw) and are already
installed inside the Top Panel
(C)
as shown in
Figure 40.
NOTE: The top access hole may be
blocked on upcoming steps.
b. Pull the Service wiring through the Service
Bushing (M) as shown in Figure 41.
c. If Load Sharing will be utilized, pull the Signal
wiring through the small bushing (N) .
d. Follow the TESLA
®
EVSE Installation Manual
to complete the Wire Connections.
NOTE:
The meaning of wiring colors might vary
from country to country. Follow all applicable
national and local regulations concerning
wiring color codes.
6. WARNING! SILICONE MUST BE USED
TO COMPLETELY SEAL THE TESLA TOP
ENTRY BRACKET (Q) FROM THE
PMD-10 TOP PANEL (C) AS SHOWN IN
FIGURE 41.
TESLA
®
EVSE INSTALLATION
(continued)