ClipperCreek ProMountDuo PMD-10T, Руководство по установке

Страница: 25 / 40

Page 25
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
ClipperCreek
, Inc.
INITIAL PEDESTAL INSTALLATION
(continued)
7. INSTALL THE HOLSTER(S)
a. If installing only TESLA
®
EVSE,
plug ALL eight (8) holster holes with
#10 screw and washer sets (E) & (I)
then proceed to the TESLA
®
EVSE
installation chapter.
b. If installing a ClipperCreek EVSE,
a Holster for the SAE-J1772™
Vehicle Connector will accompany
each new EVSE. Remove the
Holster(s) from the EVSE packaging.
WARNING: Discard the two wood
screws used for wall mounting the
Holster (these screws accompany
the holster packaging). DO NOT
USE WOOD SCREWS ON THIS
PEDESTAL INSTALLATION.
c. Align the screw holes on the Holster
with the corresponding screw holes
on the appropriate side of the Top
Panel
(C)
. Make sure the opening
of the Holster is facing the same
side and directly to the left of the
corresponding EVSE position. There
are two Holster positions to choose
from for customer convenience. The
top position is the standard mounting
location.
d. Secure the Holster to the Top Panel
with two (2) of the #10 screw and
washers sets
(E)
&
(I)
and tighten
securely as shown in Figure 17.
e. Repeat on opposite side of pedestal
for a Dual Mount system.
f. Plug any unused holster holes with
#10 screw and washer sets
(E)
&
(I)
as shown. Note: Figure 18 is Single
Mount; there will be another holster
on the opposite side if installing a Dual
Mount system.
THE INITIAL PEDESTAL INSTALLATION IS NOW COMPLETE. PLEASE REFER TO THE HCS, LCS/ACS
AND/OR TESLA
®
EVSE INSTALLATION SECTIONS ACCORDING TO THE CONFIGURATIONS DESIRED.