CLIMIA CMK 2600, Руководство по эксплуатации

Страница: 9 / 20

Local room air conditioner CMK 2600
In cooling mode the unit creates
warm moist exhaust air, which
must be conducted away from the
room to be cooled. For this reason
it is necessary to plug the exhaust
air hose provided into the outlet
opening on the rear of the unit.
• Ensure that the catches for the
exhaust air
hose latch
securely
into the two
openings
of the
connection aperture. In order to
be sure of effective operation,
do not lay the flexible exhaust
air hose with tight bends and do
not kink it.
• The exhaust air of the unit
contains a certain amount of
moisture. For this reason it is
advisable to feed the exhaust
air to the outdoor area or to
outdoors.
Exhaust air routing variants
You can route the exhaust air out of
the building as follows:
Via a flat nozzle
The flat nozzle supplied can be
used in various different ways. It
is possible to feed the flat nozzle
through an open window and fasten
it by means of Velcro and a window
suction cup
(Fig. 5, page 9)
.
Likewise the flat nozzle can be hung
in a tilted window
(Fig. 6, page 9)
.
8.0 Before commissioning
The unit is positioned at the desired
location with the discharge side
pointing into the room. When
positioning, observe the following
notes.
• After unpacking the unit let it sit
on its transport rollers for at least
5 minutes before you switch it
on.
• Set the unit down in a stable
position on
a level and
firm floor. If
the floor is
uneven then
this can lead
to vibrations
and disturbing
noises.
• Check
whether the
stopper in the
condensate
drain is present
and correctly
installed. There
is a risk of
uncontrolled
condensate leakage after
commissioning.
• Never operate
the unit without
the air inlet
filter.
Otherwise, the
fins of the heat
exchanger can
become dirty and the unit loses
performance.
• Ensure that persons and sensitive
objects, such as plants, are not
placed directly in the air flow
emerging from the unit.
Condensate
drainage with
stopper
Recirculated air
filter
• All extensions
to the power
supply must be
of a sufficient
cable size and
must only
be used fully
rolled out.
Conduct the warm exhaust air away
CAUTION!
There must be a minimum
clearance of 30 cm between the
rear of the unit and the wall.
OUR TIP
In addition, with direct solar
radiation close the curtains and
blinds and keep the windows and
doors closed during
operation.
CAUTION!
The exhaust air hose should
always be laid rising in the
direction of air flow and must not
be extended.
9