CLIMET INSTRUMENTS CI-90A, Руководство оператора

Страница: 8 / 44

CI-90A User’s Manual
Page 2
1.3.2 Power requirements
The CI-90A is powered by an external power supply (15V 4.0A) equipped with a
universal input AC power supply that supports inputs from 100–240 VAC, 47–63 Hz.
1.3.3 Safety
The operator or maintenance person should not remove any of the covers on the
CLiMET microbial sampler, except in accordance with the procedures provided by the
manufacturer.
The CI-90A contains a 9.6 volt, maintenance-free, rechargeable nickel metal hydride
battery, which can be replaced by the user.
The CI-90A external power supply comes with a three prong, grounded AC power
cord. Do not use a two-to-three prong adapter unless its ground connection has been
properly connected to a good ground on the wall socket.
1.3.4 Cleaning
The CI-90A’s enclosure, sample lid, and polyester overlay are resistant to most
cleaning chemicals. When cleaning the unit, follow these precautions:

Turn the unit off and remove the power cord.

Install the transit lid to prevent fluid from entering the blower assembly.

Cover the power input connector and the printer opening.

Wipe the surface of the unit with a cloth or wipe, dampened with cleaning
solutions. Do not allow the cleaning solution to saturate the printer mechanism.

When cleaning agents are sprayed near the instrument, be sure that the
instrument is off, and that the transit lid is installed.
1.3.5 Storage
If the CI-90A is to be stored for three months or longer without use, the battery should
be disconnected to prevent damage to the battery from a deep discharge. To gain access
to the battery, unscrew the two thumbscrews on the battery cover on the bottom of the
unit. The battery has a single connector that needs to be unplugged to permit removal
(see figure on page 3). Reconnect the battery again before use. Make sure that no wires
or cable assemblies are pinched when reassembling the enclosure.