Climbing Technology by Aludesign S.p.A. via Torchio 22
24034 Cisano B.sco BG ITALY
www.climbingtechnology.com
4/31
IST23-2A637CT_rev.3 04-21
ENGLISH
The instruction manual for this device consists of general and specific instructions,
both must be carefully read and understood before use.
Attention!
This leaflet
shows the specific instruction only.
SPECIFIC INSTRUCTIONS CHEESE PLATE S-L.
This note contains the necessary information for a correct use of the following
product/s: cheese Plate S-L rigging plates.
1) FIELD OF APPLICATION.
This product is a personal protective device (P.P.E.); it is compliant with the Regu-
lation (EU) 2016/425.
Attention!
For this product the indications of the standard
EN 365 must be respected (general instructions / paragraph 2.5).
Attention!
For
this product a periodic thorough inspection is compulsory (general instructions /
paragraph 8.)
1.1 - Intended uses.
The equipment is designed for the following applications:
protection against falls from a height if it is used in conjunction with equipment that
limits the load to 6 kN during a fall from a height (energy absorber); prevention of
falls from a height if it is used for work restraint or work positioning.
2) NOTIFIED BODIES.
Refer to the legend in the general instructions (paragraph
9 / table D): M6; N1.
3) NOMENCLATURE
(Fig. 2). A) Main connection hole. B) Secondary connection
holes.
3.1 - Main materials
. Refer to the legend in the general instructions (paragraph
2.4): 3.
4) MARKING
.
Numbers/letters without caption: refer to the legend in the general instructions
(paragraph 5).
4.1 - General
(Fig. 2). Indications:1; 4; 7; 8; 11; 12; 14.
4.2 - Traceability
(Fig. 2)
.
Indications: T1; T3; T8.
5) COMPATIBILITY.
5.1 - Connectors.
For the connection only use EN 362 connectors specific for
work at height or mountaineering-specific EN 12275 connectors equipped with
locking gates.
5.2 - Anchor points.
Only use anchor points complying with EN 795 standards
(minimum strength 12 kN or 18 kN for non-metallic anchors), located above the
user’s position.
6) INSTRUCTIONS FOR USE.
Rigging plates are designed to help organize tidy workplaces and rig multianchor
systems.
Attention!
Examples of recommended use are shown in figure (Fig. 5).
Attention!
The arrows used in some diagrams show the displacement of a load
along a cableway (Fig. 5.2-5.3-5.7). They are equipped with a main hole that
allows for the connection of multiple connectors and various secondary holes only
suitable for the connection of a single connector each.
Attention!
Each connector
can only be used in one hole. While in use, make sure that: the connectors work
along their major axis and are properly locked; that they are free to move through-
out the holes; that they do not hinder one another or other elements of the system.
7) SYMBOLS.
Refer to the legend in the general instructions (paragraph 15): F1.
