Climax FF5000, Руководство по эксплуатации

Страница: 33 / 102

P/N 36668, Rev. 4 Page 23
4.3.2 To set the feed speed/direction when flat facing
1. Turn the air control valve clockwise until it is completely closed.
2. Be sure the pneumatic conditioning unit is correctly connected and set up.
3. Connect the supply air line.
WARNING
The motor can operate unexpectedly when the air hose is
connected. Close the valve to the pneumatic motor before
conecting the air hose.
4. For manual feed, the feed direction selector must be in the neutral position.
CAUTION
Lock out and tag ou the pneumatic conditioning unit before making
adjustments to rotating parts.
5. To roughly adjust the turning bar and tool head position, loosen the eight screws
below the handle in the main body and slide the turning bar to the desired
position.
6. Set the feed direction selector to NEUTRAL.
7. Open the air control valve so that the machine will start rotating slowly.
8. Move the feed speed arm to the desired feed rate setting.
9. Open the air control valve counter-clockwise until the machine is rotating at the
desired RPM.
10. Allow the flange-facing machine to complete facing the flange.
11. Repeat Steps #1 through #10 as necessary.
WARNING
Rotating machinery can cause serious injury. Turn off the air
control valve and disconnect the air line before removing chips.
Remove chips with a brush.
12. After facing the flange, close the air control valve and disconnect the air supply.
13. After the flange is completely re-faced, disconnect the air supply.
14.
To remove the machine from the work piece, see “
Disassembly.
”
All manuals and user guides at all-guides.com