Climax FF5000, Руководство по эксплуатации

Страница: 25 / 102

P/N 36668, Rev. 4 Page 15
Do the following proceedure to roughly adjust the turning bar and tool head.
1. Loosen the eight screws below the handle in the main body.
2. Slide the turning bar to the desired position.
3. Retighten the screws.
The tool head adjusts to enable cutting at many different angles. The tool holder
swivel rotates 90º counterclockwise and 72º clockwise, when facing the tool head.
The tool holder slide provides up to 2.0" (50.8 mm) of tool bit travel.
See
“Cutting A
ngles, Grooves, and C
hamfers” for more information.
The flange facer rotates counterclockwise as seen from the top.
CAUTION
Swiveling the tool head beyond its stated limits can disengage the
slide and cause damage
3.7 Adjusting the tool head
4. Loosen the two screws above and below the feed pinion gear.
1. Rotate the tool holder to the necessary angle.
2. Clamp the tool bit into the holder. The tool bit should barely touch the surface of
the flange.
3. Check that the tool bit faces the proper direction for cutting.
4. Tighten the setscrew.
5. Attach the crank handle to the side of the machine.
6. Set the feed to RADIAL by lightly applying pressure on the feed selector lever
while turning the crank handle.
7. Crank the tool head to the start position of the cut.
8. Set the feed to VERTICAL by lightly applying pressure on the feed selector lever
while turning the crank handle.
9. Crank the tool head down until the tool bit is at the desired cutting depth. An
indicator may be placed on the top of the tool bit or tool slide to accurately
measure this adjustment.
10. The feed speed/direction arm must be in the neutral (center) position.
The tool bit clamp can be rotated to provide clearance around the tool without having
to grind a relief.
All manuals and user guides at all-guides.com