Climax BW5000, Руководство по эксплуатации

Страница: 31 / 124

P/N 68191, Rev. 4 Page 27
Install Conduit from Wire Feeder to Torch.
Ensure that the O-rings are lubricated before installing. Install bullet end into Wire feeder, and
tighten wing nut to secure. Install other end into torch, and secure nut by hand only. Avoid using
a long conduit whenever possible, creating smooth curves to aid in unrestricted wire feeding.
Contact Climax for special length conduits if needed.
Attaching Wire Feeder Gas Hose
Attach the 40 inch section of 1/4 inch (6.35 mm) rubber hose from the wire feeder nipple at the
conduit inlet, to the nipple at the rotatable power coupling. This hose passes the shielding gas
from the power coupling to the torch.
Figure 7 Cable and Hose Assemblies