Climax BW5000, Руководство по эксплуатации

Страница: 25 / 124

P/N 68191, Rev. 4 Page 21
Position of BW5000 on Rails
Set the BW5000 down on the rails with two leveling screws on one rail, and the third screw on
the second rail. The AutoBoreWelder should be positioned so that the Mounting Plate Assembly
/ Spindle is approximately central to the bore to be welded—within 1 inch (203.2 mm).
Installing Line Bar
Before proceeding with the installation of the Line Bar (2) into
the Line Bar Coupling (3), ensure that the two setscrews (1)
which hold the Line Bar in place are unscrewed far enough
so they do not protrude into the taper area. Use a 1/4 inch
(6.35 mm) Allen wrench to turn these screws.
Remove the Safety Pin (4) that is chained to the Line Bar
Coupling, and retrieve Line Bar.
Insure that the tapered male and female surfaces of the Line
Bar and Line Bar Coupling are free of dirt and grease. Insert
the male taper section of the Line Bar into the Line Bar
coupling female taper, and immediately install the safety pin
into the crosshole. Tighten the Clamping Set Screws that
drive the taper together. Do not over tighten, as excessive
force can distort the Line Bar taper area.
Figure 2 Rail Offset from Center
Figure 3 Line Bar & Coupling