Panic Alarm
:
1
key +
3
key.
Fire Alarm
:
4
key +
6
key.
Medical Alarm
:
7
key +
9
.
Change of Battery
I.
Put the Control Panel to programming menu to bypass the Keypad tamper alarm.
II.
Dismount the Remote keypad.
III.
Take out the old battery and press any key to discharge before replacing the new battery in the battery compartment.
IV.
Close the case using the rear fixing screws.
V.
Screw back the Remote keypad to the surface with mounting screws.
VI.
Put the Control Panel back to normal operation mode.
<NOTE>
The Keypad NFC tag sensor is powered on 10 seconds after inserting battery.
Fault Conditions
When Remote Keypad is under NORMAL OPERATION MODE
a)
When fault event exists in Control Panel, the arming command from Keypad will be ignored by Control Panel. The
Keypad Red and Orange LED will flash for 3 seconds along with 4 beeps to indicate error. You can override the fault
event and force arm the Control Panel by performing the arm action again.
b)
If the
Control Panel
is under Arm Mode, you
CANNOT
activate Home mode with Remote keypad. The Keypad Red
LED f Orange LED flashes for 3 seconds along with 4 beeps to indicate transmission error.
c)
If sent Arm/Home/Disarm signal but have no response from the Control Panel, the Red LED f Orange LED
flashes for 3 seconds along with 4 beeps.
d)
When incorrect Keypad PIN code is entered to enter Test mode, The Keypad will emit 4 beeps. If incorrect Keypad
PIN codes are entered for 4 times, the Keypad will disable key input function for 1 minute and indicate error by
flashing all LEDs for 6 times and emitting 6 beeps. All key press during the next 1-minute period will be ignored.
After 1 minute, the Keypad will return to normal operation and emit a long beep to indicate
Appendix
If you have forgotten the Keypad PIN Code or anything wrong happened in the Remote keypad, you can reset the Remote
keypad to factory default and reinitialize it.
Reset to factory default:
Step 1 Remove the batteries and release the tamper.
Step 2 Press & hold
3
key while inserting the battery back.
Step 3 Continue pressing
3
until three short beeps to indicate successful reset.
Step 4 Release
3
key, the reset process is complete.
<NOTE>
After reset, Keypad PIN code reverts to factory default values,
0000
and clears all user code and tag data. Remote
keypad will need a new learn-in process to start functioning.
5