DUAL HOSE WINDOW KIT INSTALLATION
WINDOW KIT ASSEMBLY
5
6
ASSEMBLY & INSTALLATION
Quickly and efficiently cool a large area.
The venting kit must be installed in order for the unit to work correctly in the air
conditioning, heating or dehumidifying mode. The venting kit does not need to be
used while the unit is fanning.
The window kit has been designed to fit into most vertical and horizontal window
openings. The window kit can also be used in a sliding door.
1. Choose a suitable location, near a grounded electrical outlet and a suitable window
or door. Remove packaging.
2. Remove the outlet covers from the back of the unit by screwing them
counter-clockwise, then lifting up
3. Pull out one end of the exhaust hose, then screw on the adapter (clockwise).
Repeat on other exhaust hose.
4. Pull out the opposite end of the exhaust hose, then screw on the window kit
adapter clockwise. Repeat on other exhaust hose.
5. Mount the exhaust hoses onto the back of the unit
6. Open the window or door and adjust the length of the window kit to fit the opening
If necessary, mark the kit and cut down one end to properly fit the opening.
7. Attached the window kit adapters to the window kit. Close the window or door
tightly. Your Portable Air Conditioner is now ready to cool!
NOTE: When using the venting system, keep the exhaust hose as short and straight as
possible. The exhaust hose can be shortened, but it is not recommended to increase
the length of the exhaust hose. Do not use an extension cord with your portable air
conditioner.
When using to a sliding door, it is recommend to make the air outlet up to air inlet.
PARTS:
A) 2 Track Screws
B) 2 Wing Nuts
ASSEMBLY:
1. Take the track screws and screw one into each of the small holes found on the
hose panels.
2. Next, take the wing nuts and tighten them around each of the track screws. Do not
tighten the wing nuts all the way; make sure they are somewhat loose.
3. Now, place the sliding track panel over the track screw on hose panel.
4. Next, take the other hose panel and connect it to hose panel by placing the sliding
track panel over the track screw on hose panel.
5. The hose panels should now be connected using the sliding track panel.
6. To complete the assembly, tighten the wing nuts installed earlier. The finished
window kit should resemble the image seen below.
C) 2 Hose Panels, one with Two Exhaust Hose Openings
D) 1 Sliding Track Panel
WINDOW KIT
