Fore Aire - 12v/48v Club Car Precedent - Installation Instructions
__ ________
6
viii.
Replace the Saw Guide and secure it with the three
screws into the original holes.
ix.
Using the Jig Saw on a low speed setting, begin
cutting at the Saw Guide notches, taking care to stay
within the slots and stopping just before you reach the
slot end.
x.
Repeat this for all four slots and then remove the Saw
Guide. Save the three screws for step 2F.
xi.
Carefully cut the four remaining segments and use a
deburring tool to clean up the hole edges as needed.
(Figure 8)
xii.
Flip the roof over so the underside faces up.
2.
Fan Installation
a.
Remove the adhesive backings from the Mounting Plate
(I)
and set it on the roof underside so that it aligns with
the Main Mounting Hole. (Figure 9)
b.
Using the plate as a guide, drill pilot holes through the
Mounting Plate in 8 places
with a 1/16” drill bit
.
(Figure 9)
c.
Flip the roof over to the upright position.
d.
Remove adhesive backing from Base
(B)
.
e.
Drop the power connecter through and lower the Base
into the Main Mounting Hole while taking care not to
damage the roof seal gasket. Ensure proper orientation as
per Figure 10.
Figure 8
Figure 9
