Fore Aire - 12v/48v Club Car Precedent - Installation Instructions
__ ________
13
Note:
Pictures may not match actual battery configuration. Always
confirm correct terminals before hooking up the Fore Aire
b.
Replace the dash panel, floor mat, baseboard, and rear
battery compartment panel.
c.
Secure fuse and dress wires in battery compartment with
cable ties. Replace the seat.
Congratulations, the installation is complete!
Troubleshooting
Problem:
Unit will not power on.
Cause 1: The Fore Aire needs to be reset.
Solution:
Reset the Fore Aire by turning the cart key-switch to the off
position while ensuring the Fore Aire is set to mode 1 (off). Once both
are off, turn the key-switch on first, then power-on the Fore Aire.
Cause 2: Inadequate power connection
.
Solution:
Ensure proper harness connections, including the power
connector, harness adapter, and switched power connection.
Cause 3: Inadequate battery connection.
Solution:
Check battery terminals to ensure a clean, proper connection
to the positive and negative terminals.
Cause 4: Improper switched power connection.
Solution:
Using a volt/ohm meter, ensure a proper 12v or 48v
connection when cart key is turned off/on.
Cause 5: Battery fail-safe sensor
Solution:
Recharge the cart batteries. The fail-safe sensor will
automatically shut the Fore Aire off when battery voltage drops below a
preset threshold.
Problem:
Electronic Eyes will not power off the fans.
Solution:
Ensure there are no objects in path of the Electronic Eye beam.
Any objects left on or around the seat could fool the Fore Aire into
thinking a passenger is present.
Figure 29 (
48v
)
