© 2003 directed electronics, inc.
21
remote siren silencing
While the siren is sounding, press the arm/disarm button once to silence the siren but
leave the system in the armed state. To disarm the system, press the arm/disarm but-
ton a second time.
N
NO
OTTEE:: If the remote control battery is low, the siren will generate a single low pitched
chirp when disarming.
multiple event total recall
This will report the last eight system triggers.
1.
Press and hold
of the PlainView 2 Valet switch.
2.
While still holding
, arm and disarm the system, then release the button.
3.
The LED will start to blink to indicate the most recent trigger and proceed down
to the eighth trigger. If fewer than eight triggers are stored in memory, the LED
will blink continuously until the system is armed/disarmed or the ignition is turned
on. For more information, please refer to the Table of Zones section of this guide.
table of zones
When using the diagnostic functions, use the Table of Zones to see which input has
triggered the system. It is also helpful in deciding which input to use when connecting
optional sensors and switches.
N
NO
OTTEE:: The Warning Zone response does not report on the LED.
LED Flashes
Trigger type
Input description
1
Data
Proximity Sensor
2
N/A
Not Used
3
Mux 1
Sensor Input
4
Instant
Door Pin Input
5
Instant
Trunk Pin Input
6
Instant
Hood Pin Input
7
Instant
Ignition Input
8
Mux 2
Sensor Input
9
N/A
Not Used
10
N/A
Alarm power reset
