© 2006 directed electronics—all rights reserved
17
reverse, and show no voltage or ground when NOT in reverse.
2.
When the intellistart is programmed to Manual transmission mode (H3/1
black/green is NOT grounded) connect the H3/10 blue/green wire to the park-
ing brake indicator wire. The wire should show ground when the parking brake
is set, and +12V when the parking brake is NOT set.
h3/11 brake light input (+)
The IntelliStart monitors the brake light to prevent an unauthorized driver from driv-
ing the car. The brake light input wire MUST be connected and brake light must be in
working condition. This connection is not necessary if the alarm is already connected
to the brake with the H2/11 wire on the main control module (preferred).
h3/12 black/gray rpm input
This wire monitors the RPM of the vehicle during remote start sequence. Connect this
wire to the vehicle coil’s negative side or the non-common fuel injector wire.
