Sys tem Check list & Trou ble shoot ing (Con tin ued)
Step 7.
Test the Valet Switch
.
n
Test the valet code and switch operation. Use the instructions provided on page 13 to
enter programming mode. If the system enters programming mode, the switch and valet
code are in operating order. If not, perform the following tests:
n
Check the WHITE/BROWN wire, ignition input is on and verify that it shows +12V
when the ignition is turned ON and +0V when the ignition is OFF. If not, refer to the
Starter or Ignition Immobilization Circuit
on page 10.
n
Test the WHITE wire at the control unit connector. It should rest at 5 volts. When
pressing the marked side, it should read 3 volts and when pressing the unmarked side it
should read 0 volts. If any reading is incorrect, move the voltmeter to the BLACK wire
at the valet switch. It should read 0 volts at rest, 0 volts when the marked side marked
is pressed, and 0 volts when the unmarked side is pressed. If the BLACK wire tests
correctly and the WHITE wire does not, replace the switch. If the BLACK wire tests
incorrectly, repair the ground circuit. If both wires test correctly, then the valet code
has been changed. Use the CliffNet Wizard Pro to reset the valet code.
Step 8.
Test the dis arm func tion.
Disarm by pressing the
button on the remote control. The following should occur:
n
Siren chirps once
. If the siren does not chirp once, refer to step 3.
n
Parking lights flash once.
If the parking lights do not flash once, refer to step 4.
n
LED stops flashing.
If not refer to step 6.
n
Doors un lock.
If not refer to step 5.
n
Optional in te rior cour tesy light(s) turn on
and stay on for 30 sec onds or un til the
ig ni tion is turned on, which ever oc curs first.
§
If the in te rior light(s) do not turn on, ver ify that you re placed the interior light fuse
you re moved or have turned the lights back on as noted in step 1 of this sec tion.
§
Make sure that the optional relay is wired correctly.
§
Check the door trig ger cir cuit. See step 8 for more information on testing the door
trigger circuit.
Step 9.
Test the Dual- Zone Piezo Sen sor.
Arm the system and tap the car softly with your fist. The following should occur:
n
Siren chirps five times.
Proceed to the next test.
Hit the car firmly with your fist. The following should occur:
n
Alarm triggers.
Proceed to step 10.
n
If either of these test fail, adjust the sensor using the adjustment knob and retest.
Step 10.
Test the door trig ger cir cuit.
Rearm the sys tem. Wait at least 10 seconds (if the vehicle has delayed or dimming courtesy
lights, be sure to wait at least 10 seconds after the interior lights have turned off)
.
Use the key
to unlock and open the driver’s door.
n
Siren sounds, parking lights flash repeatedly.
This is the correct response, proceed to
step 11. (You can silence the siren by press ing the
button on the re mote con trol
once or disarm by pressing the button twice.)
20
