CLEOPATRA Cleo Premium Pro 1532, Инструкция по монтажу

Страница: 23 / 52

23
The installation site of the steam generator depends largely on the location
of the steam distributor (see chapter 5.4). To ensure proper functioning
of the steam generator and to obtain an optimal efficiency , the following
points must be considered and observed when choosing the location for
the steam generator:
– Install the steam generator so that the
length of the steam hose is kept
as short as possible ( max. 4 m ) and that the minimum bend radius
(R= 300 mm) and up-slope (20 %) or down-slope (5 %) of the steam
hose is observed (see chapter 5.4.5).
– The steam generators
Cleo Premium Pro
are designed for wall­mount­
ing. Make sure that the construction (wall, pillar, floor-mounted console,
etc.) to which the steam generators are to be mounted, offers a suffi-
ciently high load-bearing capacity (take notice of the weight informa­
tion found in the dimension sand weights table above), and is suitable
for the installation.
– The back panel of the Cleo Premium Pro is retaining heat during opera­
tion (max. surface temperature of the metal housing approx. 60 ­ 70 °C).
Make sure, therefore, that the construction (wall, pillar, etc.) to which
the unit is to be mounted, does not consist of heat­sensitive material.
– Install the steam generator in such a manner that it is
freely accessible
with sufficient space available for maintenance purposes (refer to the
above illustration for minimum distances).
– The
Cleo Premium Pro
is protected according to
IP21
. Make sure the
units are installed in a drip­proof location and the admissible ambient
conditions are complied with.
– The steam generator Cleo Premium Pro may only be installed in rooms
with a floor drain.
CAUTION!
If for some reason the
Cleo Premium Pro
must be installed in a
location without floor drain, it is mandatory to provide a leakage
monitoring device to safely interrupt the water supply in case of
leakage.
– When fixing the Cleo Premium Pro use only the fixing materials sup-
plied with the unit
. If fixing with the materials supplied is not possible in
your particular case, select a method of fixing that is of similar stability.
– The Cleo ES4 is designed for installation and operation within
buildings (admissible temperature range see chapter 6.1). For outdoor
operation the Cleo Premium Pro must be placed in a weather
protective housing. If ambient temperatures near or below the freezing
point have to be expected, the protective housing must equipped with a
thermostat controlled heating of sufficient capacity. The water supply
pipe must be equipped with a trace­heating and must be insulated up to
the protective housing.