Cleco CellCore S169262 CCBA, Руководство по программированию, Страница: 61 / 70

Troubleshooting
Apex Tool Group P2398PM | 2022-07 61
5
EN
5
5.1 Error messages
Error messages for shut-off cause
Error message Description
?S? Abort due to other errors
Ang< Angle too small
Ang> Angle too large
Abbr Abort by the controller
ANF1 Transducer 1 absent
AW< Too few graphic values recorded for an evaluation
BLOC Tightened on block
Erg? Measuring board provides no result
FC< Clamping force too low
FC> Clamping force too great
FLT Servo warnings
FMK Measuring board error
FPEF Error in Snug Point Detection
FRC< Residual clamping force too low
FRC> Residual clamping force too great
FSMW Not enough rundown data
GD< Gradient too small
GD> Gradient too large
GEB? Encoder error torque/angle
IP Error output section, excessive current
IRED Current/TQ redundant
JUM Error due to the socket slipping off
KAL1 Calibration error, Transducer 1
COMM Host<-->TM communication error
LEF Bearing fault
M1< Torque M1, threshold not reached
M1> Torque M1 exceeded
M2< Torque M2, threshold not reached
M2> Torque M2 exceeded
MBO> Torque has exceeded top evaluation torque
MBU< Torque has fallen below bottom evaluation torque
MDSI Safety torque exceeded
TQUE Torque too high
TQUN Torque too low
ME> Press-in torque too high
MDTE> Maximum distribution torque exceeded
NECK Socket or nutrunner break
NOT End due to emergency stop