8
SOLENOID RETAINER
PLUNGER PIN
HAT
4. Using a 5/64" hex wrench, turn adjustment screw clockwise until plunger pin is pressed through
hat and valve plunger is fully seated in solenoid seat.
5. Depress throttle and check tool for rated speed at 90PSI. If tool does not perform according
to specifications, valve plunger may not be fully depressed. Continue to turn
adjustment screw clockwise.
Note: Do not exceed 76 in. lbs. torque.
ADJUSTMENT SCREW
5/64 HEX WRENCH
SOLENOID SEAT
VALVE PLUNGER
6. While keeping throttle lever fully depressed and using the 5/64" hex
wrench, turn adjustment screw counterclockwise until motor stops. At this
point rotate the screw an additional 1/2 turn counterclockwise.
7. Connect tool electronics. Tool should now shut off automatically at programed
torque limits.
SOLENOID RETAINER
PLUNGER PIN
HAT
ADJUSTMENT SCREW
5/64 HEX WRENCH
SOLENOID SEAT
VALVE PLUNGER
