CleaverBrooks ProFire D Series, Инструкция по установке, эксплуатации, обслуживанию и каталог запасных частей

Страница: 155 / 160

Startup/Service Report
The following information should be filled in by the service technician at startup or after any adjustment to the burner.
A copy of the startup report MUST be forwarded to Cleaver-Brooks in order to validate the warranty of the burner.
Burner Model
_______________
Serial Number
_______________
Startup Date
_______________
Adjusted by:
Date:
Accepted by:
(signature required)
Electric Motors
Voltage Amperage
L1 L2 L3 L1 L2 L3
Control Voltage
Blower Motor
Air Compressor
Air-Oil or Metering
Test Conducted
Gas Oil Control Check Test Set
Point
Low 50% High Low 50% High
Low Water Cutoff
Firing Rate MMBtu/gph Aux. LWCO
Stack Temp (gross) º F High Water Cutoff
Room Temp º F Operating Limit
O2% High Limit
CO% Operating Control
CO (PPM) Stack Temp Interlock
NOx (PPM) Flame Failure
Smoke (Bacharach) Combustion Air Switch
Combustion Eff. % High Purge Switch
Stack Draft “ W.C. Low Fire Interlock
Furnace Pressure “ W.C. Oil Pressure Switch
Blast Tube Pressure “ W.C. Oil Valve w/P.O.C. Inter-
lock
Steam Pressure PSIG
Water Temp º F High Gas Pressure Switch
Supply Oil Pressure PSIG Low Gas Pressure Switch
Return Oil Pressure PSIG Gas Valve P.O.C. Interlock
Vacuum Oil Pump “ HG Pilot Turndown Test
Oil Temp Flame Signal Pilot
Atom. Air Pressure
(For Low NOx Burners)
Gas Pressure @ Burner
Manifold “ W.C.
Inner Manifold Blast Tube Temp Interlock
Outer Manifold FGR Line Purge Switch
Center Gas Pressure “ W.C. FGR Valve P.O.C.
Gas Pressure @ Regulator Inlet PSIG
Gas Pressure @ Regulator Outlet PSIG
Pilot Gas Pressure @ Regulator Outlet “ W.C.
Flame Signal Main
Low 50% High