CleaverBrooks Master Panel 8, Руководство по эксплуатации

Страница: 24 / 60

Section 2 — Operation Master Panel 8
2-14 Part No. 750-375
Figure 2-12 System Configuration Screen
Boiler ID — These buttons allow changing boiler name. To assign a
name to a boiler, touch Boiler ID display for the specific boiler. The
keypad display will appear. Type new boiler name (up to 8 characters)
and press enter key.
HAWK ICS selection — indicates whether individual boilers use a
HAWK system. This can be any Hawk system (Hawk ICS Advanced;
Hawk 1000, 2000, or 4000). If system is a Hawk 2000 then both
Hawk ICS and Hawk 2000 must be selected as <Yes> to
communicate to the Master Panel.
Note: Some Master Panel options are unavailable for units
without HAWK controls.
Number of Boilers — Selects number of boilers for lead/lag sequence.
Valid entry is 2 to 8.
Max Temp (hot water) / Max Press (steam) — Selects maximum
design water temperature or steam pressure. Make sure that this
value agrees with the maximum design temperature/pressure for the
boiler. Valid entries for a hot water system are from 200
o
F (93.3
o
C)
to 450
o
F(232
o
C). Valid entries for a steam system are from 15 PSI
(1 Bar) to 500 PSI (34.4 Bar).
Remote Set Point/Outdoor Reset — Select <Yes> to enable.