4
of explosion, implosion or release of toxic or flammable gases arising from
overheated materials.
11. The unit shall be operated only by qualified personnel.
Safety Information
Take all necessary precautions for using any electrical device. Before
connecting the electrical supply, check to see if the supply voltage is within the
range stated at the rating label, and see to it that the device be seated firmly.
Place the unit in a safe and dry location; it must NOT touch its surroundings.
Follow the safety precautions for chemicals / dangerous materials. If needed,
please contact qualified service representative or
Environmental Conditions
Ensure the instrument is installed and operated strictly under the following
conditions:
1. Indoor use only
2.
≤95% RH
3. 75 kPa
– 106 kPa
4. Altitude must not exceed 2000 meters
5. Ambient to 40°C operating temperature
6. Pollution degree: 2
7. Mains supply voltage fluctuations up to ±10% of the normal voltage
Avoiding Electrical Shock
Follow the guidelines below to ensure safe operation of the unit.
The NANOPAC Power Supplies has been designed to use insulated wires thus
minimizing any potential shock hazard to the user. Cleaver Scientific recommends
against the use of uninsulated wires.
To avoid electrical shock:
1. In the event of solution spilling on the instrument, it must be dried out for at
least 2 hours and restored to NORMAL CONDITION before each
operation.
2. Never connect or disconnect wires loading from the power jacks when the
red indicator light of power switch is on.
3. WAIT at least 5 seconds after stopping a run before handling output leads
or any connected apparatus.
4. ALWAYS make sure that your hands, work area, and instruments are
clean
and
dry
before making any connections or operating the power supply.
5. ONLY connect the power cord to a properly grounded AC outlet.
