10
4.2 Replacing the Fuse
For additional fuses, contact Cleaver Scientific. Ltd.
To replace the fuse:
1. Turn off the main power switch at the rear of Power Supply and detach the
power cord.
2. Open the fuse compartment located inside the Power Entry Module by
inserting a small flat blade screwdriver into the slot below the ON/OFF
switch. Turn the screwdriver to gently pry open the fuse compartment.
Note
: The fuse compartment will not open with the power cord in place.
3. Pull the fuse holder out of the compartment and inspect the fuse that goes
furthest into the PSU. The outer fuse is a spare! If the fuse is burned or
there is a break in the fuse element, replace the fuse with an identical type
of fuse as provided in the fuse holder (see figure below).
4. Place the fuse holder back into the compartment.
5. Snap the cover closed.
Spare Fuse
