07/02/2019
Page 5
Environmental Conditions
Ensure that the instrument is installed and operated strictly under the
following conditions:
•
Indoor use only
•
≤95% RH
•
75 kPa
–
106 kPa
•
Altitude must not exceed 2000 meters
•
Ambient to 40°C operating temperature
•
Pollution degree: 2
•
Mains supply voltage fluctuations up to ±10% of the normal voltage
Avoiding electrical shock
Follow the guidelines below to ensure safe operation of the unit.
The microDOC System has been designed to utilize shielded wires thus
minimizing any potential shock hazard to the user. Cleaver Scientific
recommends against the use of unshielded wires.
To avoid electrical shock:
11.
In the event of solution spilling on the instrument, it must be dried out
for at least 2 hours and restored to NORMAL CONDITION before each
operation. NEVER connect or disconnect wire leads from the power
jacks when the power is on.
12.
WAIT at least 5 seconds after switching off the unit before handling
output leads or connected apparatus.
13.
ALWAYS make sure that hands, work area, and instruments are clean
and dry before making any connections or operating the power
supply.
14.
ONLY connect the power supply to a properly grounded AC outlet.
