ClearView SD4250, Руководство пользователя

Страница: 7 / 20

1.1.3.1.1 Set RF Output
Move the cursor to “Set RF Output” and enter into it. Then its sub menu shows as below (Press ‘up or down’ key to
select, then press the ‘enter’ key to confirm):
1.1.3.1.2 Retrieve Status
Move the cursor to “Retrieve Status” and enter into it. Then its sub menu shows as below (Press ‘up or down’ key to
view, there just show the default value):
1.1.3.2 Video
Move the cursor to “Video” and enter into it. Then its sub menu shows as below (Press ‘up or down’ key to select, then
press the ‘enter’ key to enter):
1.1.3.2.1 Set Video
Move the cursor to “Set Video” and enter into it. Then its sub menu shows as below (Press ‘up or down’ key to view,
there just show the default value):
2.1. Set Video
1.1.1. Country
New Zealand, Australia
Europe
1.1.5. Constellation
64-QAM, QPSK,
16-QAM
1.1.7. Guard Interval
1/32, 1/16, 1/8, 1/4
1.2. Retrieve Status
Country: Australia
Frequency: 564.5.00
Output Level: 90.0
FFT: 8K
Constellation: QAM64
FEC: 7/8
Guard Interval: 1/32
I/Q Swap: disable
2.1.1. Encoder 1
2.1.1.1. Multiplexing
Yes, No
2.1.2. Encoder 2
(Sub menu same as Encoder1)
2.1.3. Encoder 3
(Sub menu same as Encoder1)
2.1.4. Encoder 4
(Sub menu same as Encoder1) 2.1.1.3. Video Mode
AUTO, NTSC,
PAL
1.1.2. Frequency
CH-Num: 33 RF: 564.500
1.1.3. RF Output level
90.0dBuV(80-95)
1.1.4. FFT
2K, 8K
1.1.6. FEC
1/2, 2/3, 3/4, 5/6, 7/8
1.1.8. I/Q Swap
OFF, ON
2.2. Tune Color 2.3. Retrieve Status
2.1.1.2. Video Input
CVBS, YPrPb
2.1.1.4. Encode Bit Rate
6.000 Mbps (2-8)