ClearSpan Value Line 106178, Руководство по сборке

Страница: 9 / 23

9
CLEARSPAN
™
VALUE LINE
Revision date: 06.21.08
2. Insert the plain end of one (1) 75'' purlin pipe into each
end clamp at the bottom of the end rafter.
CAUTION: To prevent cover damage, the ends of the
purlins should extend no more than ½" past the end
clamp. The bolt side of the end clamps must go toward
the “inside” of the shelter (the same side as the purlin)
as shown below.
3. Slide a band clamp on each of the two bottom purlins.
Make sure the heads of the band clamp bolts are
toward the outside of the shelter.
5. Install a cross connector and insert the purlin pipe
through the connector at the top of the interior rafter
and also through the end clamp at the top of the end
rafter.
Inside of
shelter
1/2"
6. Verify that both rafters are plumb and properly spaced
(5' on center).
7. Tighten the cross connector at the top of the interior
rafter and tighten the end clamp at the top of the end
rafter.
8. Move to the lower end of the rafters and position the
purlin 4-6" up from the finished grade.
5'
center-to-center
5'
center-to-center
#QH1400
FRAME ASSEMBLY (CONTINUED)
4. Position an inside rafter from the end rafter using an
on-center, rafter-to-rafter spacing of 5'. (Another person
is required to hold the rafter in position.)
4-6"