ClearSpan Value Line 106178, Руководство по сборке

Страница: 15 / 23

15
CLEARSPAN
™
VALUE LINE
Revision date: 06.21.08
PREPARE MAIN COVER
Gather the parts:
• Ratchet (1" 4000lb)
• Pipe 1.315" x 75" swaged
• Pipe 1.315" x 61.5" plain
• Cover
• Tek Screws
Assembly Procedure:
NOTE: When handling the main cover and setting it in
position, do not pull on the end straps. They will pull out of
the cover.
WARNING: To prevent damage to the cover and to
prevent serious personal injury, DO NOT attempt to
install the main cover on windy days.
1. Fasten a ratchet to the end conduit with a Tek screw
in the bottom hole of the ratchet as shown below. The
ratchet should be about 6" in from the end of the
conduit. Repeat this step in all four corners.
Tek Screw
End Panel
End Conduit
Ratchet
6"
2. Assemble two main cover conduits. Start each conduit
assembly with one plain pipe and add swaged pipes to
arrive at the correct length. This conduit is identical to
the purlins that are attached to the frame.
a. Locate all sections of pipe needed to assemble
the cover conduit.
b. Insert the swaged end of each pipe into the
plain end of another pipe until the conduit is
assembled.
c. Secure each pipe joint with a Tek screw.
NOTE: Duct tape Tek screws to prevent damage to
main cover.
These cover conduits are inserted into the pockets
sewn into the main cover. The conduits are used to
tighten and secure the main cover.
3. After assembling the cover conduits, locate the main
cover and unfold it on a clean, smooth surface near the
frame.
NOTE: Unfold the main cover with the inside surface
facing up.
4. Locate the cover ends with strapping and align with the
front and back of the shelter.
5. Insert the cover conduits into the pockets of the main
cover.
Cover Conduits
Cover
Ends w/
Strapping
NOTE:
Shelter shown above may be a different length
than this model.