4. Once the conduits are assembled and installed, fold the main cover bonnet back to expose the end rafter.
5. Using the 1" strapping provided, start at the base of the building and lace the strap around the PVC conduit that
shows through the open notches of the main cover and tie the strap end to the rafter.
6. From this point, lace the strap as shown below and work up and around the end rafter.
Frame shown differs from your shelter. The steps to secure the cover are similar however.
7. Repeat the steps to lace the strap for the remaining end of the main cover.
NOTE:
When fully laced, the PVC conduit should be even and run parallel with the rafter at both ends of the building.
End Rafter
PVC Conduit
Main Cover
Conduit Pocket
Slide the
PVC Conduit
into the main
cover pocket.
Cover and
frame shown
differ from the
actual frame.
The installation
steps are the
same however.
Do not fully
tighten the end
strapping until
the straps for
both ends are
in place.
View to the left
shows the main
cover as seen
from inside the
shelter.
Main Cover
Cover PVC
Conduit
Visit www.ClearSpan.com for additional products and customer assistance.
28 of 40
