additional ropes. This slit can be used later when the straps for the ratchets are installed.
DO NOT
cut through to the
outside of the main cover.
Cut only the sleeve in which the conduit rests.
6. With all ropes tied securely to the conduit, toss the free ends over the frame assembly and pull the cover over the
assembly and into place.
NOTE:
Use lifts and additional assistants (if needed) to help pull the cover up and over the frame.
7. Once in place, center the main cover on the frame. Center the cover side-to-side and end-to-end.
WARNING: To prevent damage and injury, do not leave the cover unattended if it has not been properly
secured. The ropes can be used to temporarily keep the cover from blowing off the frame.
8. Along the sides, lift the main cover skirt, locate the QH1065 ratchets attached to the rafters, and make a slit in the
cover conduit sleeve at these locations.
NOTE:
If ropes were used at these locations when the main cover was pulled in place, a slit may already be present.
9. Select one of the 5' tie down straps that shipped with the building and insert one end of the strap through the sleeve
opening, around the cover conduit, and back through the opening.
10. Feed both ends of the strap through the slot in the ratchet and tighten slightly.
NOTE:
If excess strap builds up in the ratchet, loosen the ratchet, remove excess strap, and retighten slightly as
needed.
Visit www.ClearSpan.com for additional products and customer assistance.
26 of 40
