Step 4:
Secure each connection by inserting a Tek screw into the middle of the overlapped area on
the side of the rafter where it will not come into contact with the main cover or the end panel.
Tip:
Tek screws are self-drilling and no pilot hole is usually required. If you have trouble
getting a Tek screw to “bite,” try another Tek screw (or you can drill a 3/16" pilot hole).
Step 5:
Repeat the steps above to assemble all remaining rafters using the same procedures.
Two of your rafters will be used on the ends of your shelter, and these end rafters use special fittings
including Purlin End Clamps and Brace Bands. You will add these fittings now.
Step 6:
Slide 2 sets of Purlin End Clamps onto each end of one of the rafters (4 clamp sets per end
rafter). These will be be used to secure the purlins to the end rafter. Turn them as required to
get past the Tek screws at the joints. You
ʼ
ll need a pair near the top of the rafter about a foot
down from the peak of the shelter and a pair just below the bend on the sides of the rafters.
Page 8