Step 8:
While standing inside the shelter, start at the peak of the end rafter and pull the end panel
over the top of the rafter so the material edge is on the inside of the rafter.
Step 9:
Secure the panel in place at the top center with a fabric clip.
Step 10:
Move outward in both directions, placing one fabric clip every 24." Then, secure each clip
to rafter with a Tek screw (on side where it won
ʼ
t contact cover).
Step 11:
Your other end panel has 2 zippers which create 3 sections when the zippers are up. Insert
the conduit only through the side portions of this end panel and not through the middle door
section. Attach the end conduit to the bottom of the last rafter using the end conduit
connectors, and tighten the allen screws in the connectors.
Step 12:
Secure this end panel up in place using fabric clips with Tek screws as you did on the plain
end panel.
Step 13:
Your end panels may have been shipped as untrimmed rectangular pieces. If so, you may
use scissors to trim the excess end panel material inside the shelter to an inch or two past the
fabric clips as shown in the illustration above.
Page 15