Visit
www.ClearSpan.com
for additional products and customer assistance.
CLEARSPAN
™
CARPORTS
20
INSTALL ROOF PANELS (continued)
SEE THE DOTS IN THE PREVIOUS DIAGRAM FOR
THE LOCATION OF THE FASTENERS FOR THE
FIRST PANEL.
The top edge will be secured to the hat channel
when the corrugated ridge cap is installed; the edge
overlapped by the next panel is secured when that
panel is installed.
7. Repeat the steps to install and secure the next panel,
which is the first, lower panel of the other side as
shown below.
8. Add the 6' upper panel (below) and secure the panel
to the hat channel. Use a section of ridge cap to verify
that the space between the upper panels is not too
wide.
NOTE:
A space will remain at the peak of the frame
between the panels. The ridge cap covers this when it
is installed.
9. After installing the first set of roof panels, attach the
first section of corrugated ridge cap.
ATTENTION:
At this time, no fasteners are installed in
the areas identified by the dashed lines. If Tek screws
are present along this edge, these must be removed to
properly install the next set of panels, which will overlap
the first set of installed panels.
10. Continue the panel installation by attaching the next
lower 8' panel.
ATTENTION:
This second lower panel overlaps the
first lower panel along the side and is tucked under the
corner of the first upper panel. See the arrows in the
above diagram.
ATTENTION:
Panels are
not designed to support
weight. DO NOT climb
on the panels during
installation.
Hat Channel where
panels overlap.
8' Panel
Tuck 8' panel under the
corner of the upper panel.
