25
CLEARSPAN
™
POLY BUILDINGS
Revision date: 05.20.20
Gather the parts:
• Pipe 1.315" x 75" swaged (#131S075)
• FA4482B Tek screws
• One (1) extension pipe (#131P072) per
assembled conduit
• One (1) spin handle (#103395) and one (1)
universal joint (#103396) per roll-up conduit
• CC6212 fabric clip for 1.315 pipe
ASSEMBLE AND ATTACH ROLL-UP CONDUIT
The following instructions describe assembling the roll-up
curtain conduit and related crank handle and extension pole.
Repeat the steps for all remaining roll-up conduits. Each roll-
up curtain panel requires a roll-up conduit and crank handle.
Complete these steps to assemble and attach one (1) roll-up
conduit:
1. Locate the sections of #131S075 pipe needed to
assemble the roll-up conduit. Assemble as many pipe
sections as needed to equal or exceed the length of the
curtain panel.
NOTE:
Assembled pipe may run a few inches or as
much as a couple of feet beyond the end of the panel.
Pipe is cut to length in a later step.
2. Secure each pipe joint using a Tek screw (FA4482B) and
wrap the connection and screw with a couple of layers of
duct tape. See diagram to the right.
3. After the conduit is assembled, move it to the first roll-up
curtain and slide the conduit into the curtain pocket.
Allow a few inches to extend beyond the pocket
at the
end where the spin handle will be positioned
.
4. Take the CC6212 fabric clips and attach one every 60"
or so along the conduit using FA4482 Tek screws to
secure the conduit to the curtain. Assistance is required.
12
Attached Roll-
Up Conduit
CC6212 Fabric
Clips
