ClearSpan 106772, Руководство пользователя

Страница: 17 / 53

CLEARSPAN
™
JOB MASTER BUILDINGS
17
Revision date: 07.23.09
OPTIONAL END PANEL INSTALLATION
These instructions describe installing the optional end
panels if equipped. If you want to purchase end panels for
the main, center frame of your Job Master Shop building,
visit us at www.ClearSpan.com, or contact your sales
representative. For a building without end panels, skip to
and continue with the installation of the end wall framing for
the outrigger frame.
WARNING:
To prevent property damage and possible
injury, do not attempt to install the end panels or main
cover on a windy or stormy day.
Required parts: End panel (or panels), Tek screws, and
neo-bonded washers.
Each end panel is designed to wrap around the end rafter
at the end of the main, center frame. Panels are then
stretched and secured to the end rafters using Tek screws
and neo-bonded washers spaced 24" apart.
NOTE:
End panels are typically shipped as untrimmed
rectangular panels. After securing the panel to the frame,
the excess material can be trimmed as desired.
Complete the following steps to install the optional end
panel or panels.
1. Locate the end panel and spread it out on the ground
at the desired end of the main frame.
2. Center the panel in the end wall opening so the zippers
are in the desired position. Middle zipper is centered on
the end wall.
NOTE: Verify that the outside of the panel is down or
toward the ground. The top of the panel is positioned
away from the frame.
3. With assistance, lift the panel up and against the end
rafter of the frame. Use additional help and the proper
lifts to safely lift the end panel into position.
4. While the panel is held in position, stretch the panel
from side-to-side at ground level.
5. Wrap the panel around the bottom of each leg of the
end rafter and secure it to the inside (or backside) of
the rafter leg using a Tek screw and washer.
NOTE: Keep the end panel at or near ground level as
desired during this step.
6. Working from the bottom toward the top, continue
wrapping the end panel around each leg of the end
rafter and securing it to the back of the end rafter.
ATTENTION: To prevent damage to the main cover
when it is installed, position all Tek screws on the
backside of the rafter. The main cover will overlap the
end rafter to finish the edge when installed.
To minimize wrinkles, keep the panel stretched evenly
as it is attached to the frame. It may be necessary to
remove and reinstall Tek screws and washers during
the process for best results and fewer panel wrinkles.
The frame shown in the following diagrams may differ from
the actual frame. The installation of the end panel is the
same for all frames within this building line.
End Panel for Center Frame
Section Top
To prevent zipper
damage, do not stretch
the panel too tight.
To prevent
zipper damage,
do not stretch
the panel too
tight.