Clear-Com Eclipse Median, Инструкция по эксплуатации

Страница: 97 / 114

Vitec Group Communications
Eclipse Median Instruction Manual 6 - 5
send you a matrix to use while the damaged one is being
repaired.
Once you have isolated the problem to the card or the backplane, it is
easier to take the next step which is to repair or replace the suspect
component.
Problem: The power supply lights do not illuminate on all
cards in the matrix.
In this situation, the most probable problem is that the matrix’s power
supplies are not sending out any electric current, since none of the
cards are receiving power. Although less likely, the problem may be in
the matrix’s backplane connectors.
The following procedure helps you isolate where the trouble is
occurring:
Check the power supplies’ alarm lights. If the power alarm lights are
indicating a problem with the power supply, swap it out with a new
power supply.
• If this repairs the problem, the problem was in the power supply.
• If the problem persists even after the power supply has been
replaced, the problem is in the matrix’s backplane connectors.
Send the matrix back to Clear-Com for repair or replacement. In
the meantime another matrix can be substituted for the damaged
one. Clear-Com will send you a matrix to use while the damaged
one is being repaired.
Problem: The power supply lights do not illuminate on one
of the two CPU cards.
When the system is functioning properly, the power-supply lights on
both CPU cards illuminate. If the power-supply lights on a CPU card
fail to illuminate, the problem may be with the card itself, or with the
backplane connectors that carry the electric current from the power
supplies to the cards. (The backplane connectors are part of the
infrastructure of the matrix and are not serviceable by field personnel.)
The following procedure helps you to isolate where the trouble is
occurring:
1. Swap the CPU cards. Put the first card in the second CPU slot and
the second card in the first CPU slot. The problem will follow the
card or the slot.
• If the power supply lights do not illuminate on the bad card (the
card with the lights out) when it is inserted in the other CPU slot,
the problem is probably in the card.
• If the power-supply lights on the bad card illuminate when the card
is inserted in the other CPU slot, the problem is probably not in
the card itself. The problem may be with the backplane
connectors or power supplies.