How to Attach the Handle to the Vacuum Cleaner
(models CMPS-1T, CMPS-1N, CMPS-QD)
The vacuum cleaner and the handle are packed separately�
1� Remove the handle screw, insert handle into the hole on top of the
vacuum cleaner� Make sure that the cord hook on the handle is
positioned to the back of the vacuum cleaner (Fig� 1)�
2� Line up the small hole on the handle with the small hole on the
vacuum cleaner and insert the screw� Make sure the screw is
tightened securely�
How to Attach the Extension Power Cord to the Cord Lock
1� Connect the extension power cord to the pigtail cord on the vacuum�
2� Snap the extension power cord into the slot on the end of the cord
lock�
3� Turn the knob on the bottom of the cord lock to tighten the lock and
prevent the cords from pulling apart (Fig� 2)�
How to Attach the Cord Retainer to the Handle
1� Pull apart the rounded end of the cord retainer to open it up enough
to fit around the vacuum handle (Fig� 3)�
2� Attach the cord retainer around the vacuum handle�
3� Create a loop in the power cord and push it through the slot and
over the hook of the cord retainer (Fig� 4)�
4� Pull down on the power cord to remove any slack (Fig� 5)�
On/Off Switch (Fig. 6)
1� To turn the vacuum on, push the switch located on the dust
compartment to the ( I ) position�
2� To turn the vacuum off, push the switch located on the dust
compartment on the ( 0 ) position�
Fig� 6
How to Assemble and Operate the Vacuum
Fig� 1
Fig� 4
Fig� 2
Fig� 3
Fig� 5
7
