How to Replace the Vacuum Belt
CAUTION: Unplug the vacuum cleaner before performing any of these steps�
How to Remove the Bottom Plate
1� Place the vacuum cleaner in the reclined position (see page 10)� Turn the
vacuum over�
2� Slide the clips toward each other (Fig� 3)�
3� Remove the bottom plate�
How to Replace the Belt (models CMPS-1T, CMPS-1N and CMPS-QD)
1� Turn the unit over and remove the bottom plate as described in the above
section�
2� Lift the belt cover and turn toward the outside (Fig� 4)�
3� Remove the agitator by pulling it straight out�
4� Remove the belt from the agitator and motor pulley�
5� Loop a new belt over the motor pulley and over the end of the agitator�
6� Stretch the belt over the agitator while inserting it back into the nozzle housing�
7� Turn the belt cover back over the motor pulley� Make sure cover releases down
into the nozzle�
8� Replace the bottom plate by hooking the front end of the plate into the two ribs
on the front end of the nozzle housing� Press the bottom plate into place by
sliding the clips away from each other�
NOTE: To ensure maximum cleaning efficiency, check the belt regularly to ensure
it is in good condition� Replace the belt if it is stretched, cracked or if excessive
slipping is occurring�
12
Fig� 3
Fig� 4
Model: CMPS-1T
These vacuums are equipped with on-board cleaning tools including a
metal telescopic wand, stretch hose, dusting brush and a crevice tool�
1� Remove the extension wand from the body of the vacuum cleaner and
attach it to the nozzle hose�
2� Insert any of the tools onto the end of the wand�
Models: CMPS-QD and CMPS-QDZ
These vacuums are equipped with on-board cleaning tools including a
metal telescopic wand, stretch hose, dusting brush and a crevice tool�
1� To use the cleaning tools, lift the hose handle straight up from the
vacuum (Fig� 1)�
2� Extend the wand by pulling the button backward and pulling the
smaller wand out of the larger wand (Fig� 2)�
3� Attach any of the on-board tools to the end of the wand or if you do
not need the wand, any tool can be connected directly onto the hose
handle�
On-Board Tool Cleaning
Fig� 1
Fig� 2
