16
Cleanfix —KS 1100—simply clean
Side brushes
Removal of the side brushes
•
Switch off of the Ride-on-Sweeper.
•
Pull the levers of the side brushes upwards
•
Locate both levers in their positions
•
Lift the side brush motor upwards in order
to get better access to the side brushes
•
Unscrew the three fixation screws in the
centre of each side brush
•
Pull downwards each side brush
•
Replace the side brushes
Side brushes exchange
Butterfly nut and hexagon Screw M10
(height Adjustment of the side brushes)
Due to wear and tear of the side brushes‘
bristles and the change in floor contact
height, it is necessary to readjust the side
brushes height from time to time.
•
Turn-Off / Switch off the Ride-on-Sweeper
•
Release the levers for both side brushes
and push them downwards
•
The side brushes are each fixed by
means of two supports. The right support
(bowden cable) is to lift or lower the side
brushes, the left support (butterfly handle
screw) is used to readjust the height of
the brushes.
Side brushes adjustment
Mounting the Side Brushes
Turn the 3 screw holes of the flange plate
of the side brushes exactly over the positi-
on of the 3 holes of the counter flange on
the side-brush-motor.
•
Screw the three fixation screws in the
centre of the side brush that it connects
and lifts the brush upwards to the counter
flange coming from the side brush motor
and is fixed tightly.
Counter flange
for side brush
Flange plate for
side brushe
Fixation screws
Spring for
constant
pressure
17
Cleanfix —KS 1100—simply clean
Cylindrical brush
Dismantling the cylindrical brush
•
Switch OFF the Ride-on-Sweeper and
remove the key
•
Turn-OFF the Main Switch and remove the
red key as well in order to prevent unfore-
seen switching ON again.
•
Pull up the lever for the cylindrical brush.
•
Locate and fix the lever in the top position.
•
Unscrew the two screws with star grip
holding the machine-side-cover on the left
side (driving view direction)
Cylindrical brush exchange
•
Push and slide the cylindrical brush under
the machine
Pay attention to the driving/turning
direction of the cylindrical brush
when fitting it into the machine.
Cylindrical brush fitting
•
Remove the machine-side-covers
The cylindrical brush is held by total three
star grips/handles. Two star grips with
screw are for the front cover. One star grip
with screw holds the rubber-flap/waste
splash protection)
•
Unscrew both front star grips and remove
the front cover.
•
Remove/unscrew the top star grip and
remove the cover of the cylindrical brush
and take out the rubber flap/waste splash
protection.
•
Pull out the cylindrical brush out of the
machine and remove all wastes, strings,
tapes etc. from the cylindrical mandrel.
2 Star grips with fixation screw in the ma-
chine-side-cover and interior cover of the
cylindrical brush
Star grips/fixation screws for the
Rubber flap below (waste splash protector)
•
At the cylindrical brush end there is
groove.
•
Turn the cylindrical brush until the pick-
up mandrel of the roller-rocker fits in the
groove of the cylindrical brush.
•
Push and slide the roller rocker over the
threaded rod.
•
Make sure, that the cylindrical brush fits
perfectly in the grooves on both sides of
the carrier and that all star grips are
fixed tightly.
Fix and screw on the machine side co-
vers.
