20
Cleanfix —KS 1100—simply clean
Battery
Description
Four Gel batteries type Dryfit each 6 V / 180 Ah provide the Ride-on-Sweeper KS1100
with power. The charging status of the batteries can be read on the battery indication on
the Operator Panel.
Operator panel
(without overhead emptying)
Battery charging indication
LED display for battery charge status
Signification of the LED lights on the battery status panel
When switching ON the Ride-on-Sweeper immediatley the LEDs start blinking, nicely one
after another, beginning at the minus/negative terminal and blinks along to the plus/
positive terminal. The result of this self-test is indicated by the 10 LED‘s..
1 LED = Working status / charging status is critical...until.
10 LED‘s = Work status / charge status is not critical, charging completed
Charging the batteries
•
Switch-OFF the Ride-on-Sweeper
•
In view of driving direction, on the right hand side,
Above the rear wheel is the socket connection for
battery charging
•
Open the cover and connect the plug of the charger to
the battery socket on the Ride-on-Sweeper
•
Now connect the power cable of the battery chargr to a
power supply socket.
•
The charging cycle requires approx. ??.hours if the battery was totally discharged and
to be recharged only by an Original Battery Charger (Original Manufacturer)
•
The Original-Charger of the Manufacturer should be connected as it allows to maintain
the charging status/trickle charge and therefore always for the maximum capacity of
the batteries even after a long standing time.
•
Make sure to only put your Ride-on-Sweeper into operation, if the battery charge status
Is sufficient. The Ride-on-Sweeper will switch off automatically if the batteries are
discharged down to a critical level which could cause damage. (low voltage/deep
discharge disconnect) In such a case all consumer loads muts be completely discon-
nected and switched OFF for one to two minutes.
Thereafter they can be reconnected and
then the machine must driven immediatly to the charger for battery charging before dama-
ge occurs. Strictly only use the drive motor (do not switch on brush/vacuum motor).
13
Cleanfix —KS 1100—simply clean
Filter exchange
The integrated lamella filter separates the
fine dust. The lamella filter is cleaned by
electric activation of vibration unit.
•
Open the main cover.
•
Secure the main cover with the sup-
port rod in top position.
The filter box cover is held and secu-
red by two rubber latches.
The interior lamella filter is fixed by 3
star grips on each side of the filter box.
•
Release both rubber holders and lift-
off the filter box cover.
•
Unscrew all 4 wing screws until the
lamella-filter frame inside is free.
Now you can pull the lamella-filter
out of the filter box.
Always replace the complete frame
with lamella-filter.
•
Insert the new lamella filter frame.
•
Rescrew all 4 wing screws (2 on
each side of the filter box) back
inside until the lamella-filter-frame is
clamped properly again.
•
Place the plastic cover back on top
of the filter box.
•
On each side of the filter box stretch
and tension the rubber fixations.
•
Carefully release the support rod
holding the machine cover and let it
down slowly and close.
Dismantling
Mounting
