12
handhold
for
buckling
Cleanfix —KS 1100—simply clean
Waste box emptying
Manual Emptying
of the Waste Box
•
Turn upwards both steel swivel-
catches which release the waste
box. They can be found on both
sides foteh waste box.
•
Pull out the waste box along the
rails, by pulling upwards and holding
the handle of the waste box.
•
The waste box can easily be remo-
ved and put back inside the machi-
ne again.
•
Pull out the waste box completely.
•
To empty the waste box grab inside
the grip of the handle
The waste box is used to collect all sweeped
wastes. It can be found at the back of the
machine.
The Waste box / hopper must be emp-
tied regularly but latest after each use.
Insertion of the waste box
•
Place the waste box in front of the
entrance of the waste box opening
at the back of the Ride-on-Sweeper.
•
Lift the waste box to the height whe-
re it can enter the opening to the
guiding rails.
•
Slide the waste box inside again
•
As soon as the waste box is
completely inside the machine the
steel-swivel catches can easily be
moved downwards to lock position.
Hydraulic Overhead Waste Emptying
•
When the waste box is full or ready
for emptying proceed according to
the Stepps 1 to 4 at the switches:
•
First switch on the ON/OFF switch
for overhead waste box emptying
•
Then tip the rocker switch to Pos.1
(lift the waste box) and then let go
the rocker switch to middle position,
i.e. „hold“
•
Now drive the Ride-on-Sweeper to
the foreseen waste container, close
enough backwards so that the
waste box is above the open waste
container.
•
Pull the handhold for buckling (2)
•
Push the handhold back to the ho-
me position (3)
•
Now you can press the rocker
switch „lower waste box“, pos.4.
Switch lifting / lowering
21
Cleanfix —KS 1100—simply clean
Brake
Danger!
The brake is a safety relevant building component! All work for
maintenance/service or exchange have to be done by qualified
and trained personell.
The brake (drum brake) affects the front wheel and is activated via the brake
pedal and bowden cable.
Adjustment of the brakes can be done on the right hand side of the front wheel
(view driving direction).
Readjustment of the brakes
•
Fix the adjustment nut of the bowden cable with a wrench.
•
Release the counter nut of the bowden cable.
•
Press the brake upwards until brake feels resistance.
•
Hold the brake in this position.
•
Turn the counternut of the bowden cable tightly.
Bowden cable
Adjustment nut of the Bowden cable
Counter nut of the Bowden cable
Brake cable
Brake lever
Brake cable fixation
Functional Test of the Brakes
Front wheel—free room of movement
The Ride-on-Sweeper should be able to be pushed forwards easily if the brakes are
unlocked. During this motion the front wheel should move easily and not block.
If the brakes are adjusted too tightly then damage could occurto the drum brakes.
Functionality of the brake
Drive carefully a few metres at low speed. Press the brake pedal, the Ride-on-Sweeper
should stop. If the functional test does succeed as foreseen, then repeat the adjustment
procedure.
Further adjustment possibility:
The Bowden cable cannot be adjusted as described above.
•
Release the brake cable fixation and lift the brake lever until it has resistance and
then hold the brake lever in this position
•
Pull the brake cable through downwards and push the brake cable fixation up-
wards.
•
Fasten the brake cable fixation in this position.
•
Proceed with the functional tests as described above
