Clavister Wolf W30, Руководство по началу работы

Страница: 69 / 94

Figure 5.2. An 8 x SFP Gigabit Interface Expansion Module for the W30
Figure 5.3. A 2 x SFP+ 10 Gigabit Interface Expansion Module for the W30
The full connection capabilities of all these Ethernet interfaces are listed in Appendix A, W30
Specifications .
Adding an Expansion Module
A W30 expansion module is added using a cold swap procedure. The steps are as follows:
1. Shutdown cOS Core and power down the W30. For safety, disconnecting the power cable is
advised.
2. Take off the plate covering the empty expansion slot. This is done by first undoing the two
retaining screws on either side of the plate. These screws may need loosening with a
suitable screwdriver before undoing completely by hand. The screws are on springs and will
spring out when they are no longer held by the thread in the chassis.
3. Attach an earthed anti-static wrist strap to the wrist of the hand that will handle the module.
Doing this is strongly advised since expansion modules are not closed units.
4. With the hand that is correctly earthed, remove the expansion module from its anti-static
bag. Try not to touch any of the exposed electronics when doing this.
5. Gently insert the expansion module by sliding it into the expansion slot, as shown below.
Chapter 5: Interface Expansion Modules
69