Clavister Wolf W30, Руководство по началу работы

Страница: 61 / 94

4.5. License Installation Methods
Without a valid license installed, cOS Core will run in demo mode (demonstration mode) which
means that it will cease to function after two hours of operation. Restarting cOS Core will
re-enable cOS Core for another two hours. To remove this 2 hour restriction, a valid license must
be installed.
Licenses are files which are made available for download from the Clavister servers but before
they become available, the user must have registered themselves with Clavister and doing this is
described in
Chapter 2, Registering with Clavister .
Installation Methods
The following methods can be used for installing the first cOS Core license in the W30 unit:
• Automatically through the Setup Wizard
As described in Section 4.2, “Web Interface and Wizard Setup” , when the wizard is used for
initially configuring Clavister hardware, the administrator can choose to install a license as
one of the wizard steps.
This method is also only available when installing a license for the first time.
• Automatically through the Web Interface
Go to Status > Maintenance > License and enter the customer's login credentials for the
Clavister website, then press Activate. The license is fetched automatically across the public
Internet and installed.
This method is also only available when installing a license for the first time.
• Automatically through the CLI
In the CLI, enter the command:
Device:/> license -activate -request -username=myname -password=mypass
The customer username and password login are included in the command and the license is
fetched automatically across the Internet. The login credentials are the same ones that are
used for Clavister website login. The
reconf or shutdown command should be used to
complete installation.
This method is also only available when installing a license for the first time.
• Manually through the Web Interface or SCP
This method is the only choice when the W30 hardware does not have a connection to the
public Internet. The procedure consists of the following steps:
i. In a web browser, go to the Clavister website at https://www.clavister.com, select Log
in and then log in to the site. This will require registration on the site if this has not been
done already.
ii. Go to Licenses > Register License.
iii. Select the option Register by Service Tag and Hardware Serial Number.
iv. Enter the Serial Number and Service Tag codes. For Clavister hardware products, these
codes are found on a label on the unit.
Chapter 4: cOS Core Configuration
61