Claudgen ScreenZone CA1309S10, Инструкция по установке и эксплуатации

Страница: 21 / 23

,VV
7RXFKVFUHHQ&RQWUROOHU2SHUDWLRQ - FRQW
10.10 Automatic Mode
Automatic Mode is the best choice for easy to
set-up efficiency and comfort. Set the height by
moving slider to the required position. The air cur-
tain will run at optimum fan speed and heat out-
put based on the inlet temperature.
10.11 Temperature Mode 1
Temperature Mode 1 is very similar to Automatic
Mode, with the addition of having an option for
adjusting the airflow temperature. With the air-
flow temperature set in the middle of the scale,
this is equivalent to Automatic Mode.
In certain situations, when required, airflow can
be increased or decreased by increasing or de-
creasing the set installation height. Using a higher
setting for the installation height will make the air
curtain less energy efficient.
10.12 Temperature Mode 2
This operating mode is suitable for situations
where the heater is used to maintain the room
temperature or where the requirement is to ad-
just the heat output based on the indoor/
outdoor temperature.
This operating mode can use either the internal
or supplied external temperature sensor.
The temperature on the left defines the starting
point below which the air curtain uses full power.
The temperature on the right defines the point
above which the air curtain doesn’t produce any
heat. As the measured temperature rises the
heat output is gradually reduced until heater
doesn't produce any heat.
Using the internal temperature, this mode can be
used to maintain room temperature.
With remote sensor installed outside, this mode
can be used to compensate for external temper-
ature.
There is also an option to select fan function after
the heater stops producing heat. Fan can be set
to turn off after the heater stops producing heat
or run all the time.